人気ブログランキング | 話題のタグを見る

What are the cleaning tips for plush toys

Plush toys can be used directly after they are bought home, and there is no special way to use them. However, it is recommended that parents should wash the toy once after buying it back, and then use it for the baby. How to clean used toys? Here are two methods for your reference.

the first method:
For plush toys that can be cleaned, first add detergent to the basin and rinse with some water. Use a general soft brush to stir the water in the basin to produce rich foam, and then use a soft brush to moisten the foam to remove the fur. Brush the surface of the plush toy clean, and be careful not to get too much water on the brush. soft toy wholesale,After brushing the surface of the plush toy, wrap the plush toy with a bath towel and place it in a basin full of clean water for pressure washing, so that the dust and washing liquid in the plush toy can be removed. Then put the plush toy in a water basin with softener to soak for a few minutes, and then press and wash it several times in a water basin filled with clear water until the water in the basin turns from turbidity to clear. Wrap the cleaned plush toys with bath towels and put them in the washing machine for dehydration. After the dehydrated plush toys are reshaped and combed, they are placed in a ventilated place to dry, and the plush toys will look like new again.

The second method:
Buy a packet of large grains of salt, namely coarse salt, put the coarse salt and the dirty stuffed toy in a plastic bag, tie the bag tightly, and shake it vigorously for dozens of times. It was found that the plush toy had become clean. The coarse salt taken out turned gray-black due to the adsorption of dirt.

The principle of this coup is to take advantage of the adsorption of salt, that is, sodium chloride on dirt. Small things such as plush collars and plush cushions in the car can also be "washed" in this way. At the same time, salt plays a role of sterilization. Finally, if it is an electronic plush toy, remember to take out the electronic parts first, so as not to damage it.


like:










by exeitebiog | 2021-11-05 18:11 | Comments(0)